Evolution Gun Works Undersize Reloading Die — 5 models

Caliber: 9mmBrand: Lee PrecisionOur Dies are maufactured by Lee Precision.If a die is available online to purchase, it is in stock. Due to high demand the inventory will be fluctuating constantly.Extra decapping pins available here.A must for the serious reloader: EGW offers custom designed, carbide sizing dies that are 0.003" smaller in diameter than typical dies. Not only is it smaller in diameter, the bottom corner is radiused which sizes the case further down. This helps prevent feed failures from cases that bulged near the base during reloading- which is typical of brass fired in Glocks and other loose chambered guns. The dies are made out of carbide.No lubrication needed. Because the carbide is so hard, no lubrication is required on the case. You will find the die will actually burnish the case and improve its appearance. The die will last a lifetime!Screw the full length sizer in until it touches the shellholder and tighten the lock ring finger tight. The decapper is retained by a collet. Should it be overstressed by an obstruction, it simply slides up without damage. To reset, loosen the decapper flush with clamp end and retighten. Considerable torque may be necessary. A and wrench are required.Undersized Reloading Dies will work with a Dillon Press if they are 550, 650, or 1050. They will not work if they are squared.

Specifications for Evolution Gun Works Undersize Reloading Die:

Package Contents:

• Evolution Gun Works Undersize Reloading Die